Voyager Ultra 2 Tent Pitching Instructions

From the classic, tried and tested Voyager, comes the lighter version. The Voyager Ultra 2 tent pitching instructions are as follows:

1. Lay out the inner tent.
2. Carefully assemble each of the 3 poles. Ensure all the joints are fully inserted.
3. Using the diagram linked below, lay the poles over the inner tent as follows.
   – Pole 1 (blue) diagonally between A and B, making sure the pre-curved section is at the back of the tent.
   – Pole 2 (blue) diagonally between C and D, making sure the pre-curved section is at the back of the tent.
   – Pole 3 (red) between E and F.
4. Insert a pole-end into the outer most eyelet of each inner tent eyelet tape. The tapes are colour-coded to match the relevant pole.
5. Clip the inner tent to the poles.
6. Throw the flysheet over the inner tent.
7. Hook flysheet eyelet tabs to pole end-tips.
8. Insert each pole-end into the corresponding eyelet tape on the hem of the flysheet. Note: The eyelet tapes are colour-coded to match the relevant pole.
9. Peg out the tent.
10. Adjust the flysheet tension if required.

The Voyager Ultra 2 is supplied with the following:

• 3 x alloy poles (1 x red, 2 x blue)
• 12 x 1g pegs

Voyager Ultra 2 Tent Pitching Video